Separate front and rear pieces
Roller skate plates ate typically one per boot. Have you tested out the skateboard approach where the front baseplate-hangar-anxle (BHA) and rear BHA are mounted to the boot separately? I was thinking about why the front and rear BHA needed to be aligned [along the same line]. Could there be "performance gains" from having them parallel to the line as opposed to on the line?
Have you experimented with something like that?
Comments
Like So?? Never played with having them off axis. These are Snyder parts and not inexpensive. I would suggest Sure Grip hangers and trucks. Less money. I would also suggest a Bont boot. They will hold up much better to not having any plate to speak of under the sole.
Or you could put a thin aluminum plate between the hangers and boots kinda like an old school dance plate. Just leave more room to move the hanger mounts.