Fila M100 - How to stretch?
Hi
Is it possible to stretch the width of File M100 skate ? Internet say is a carbon fibre - not heat moldable boot?
If so how or ideas on how I could make this more comfortable.
The length is fine, but I can only bear a minute or two of skating before the pain becomes too much. I need a little more width (wide feet) and these would be much better.
Returning to inline after a years away (and I suspect I stopped because of foot pain and narrow skates). Using some RB8s but I don't like the Velcro strap and want a proper buckle for a tighter ankle fit (at least initially - longer term going to get back on some speed skates)
Thanks
Comments
Nope non moldable. I had M110, same problem wide feet. So I took out stock insole and replaced by a very thin one. And h asd to wear very thin socks.
From The Netherlands
Also these Fila liners are small cut. If you want a better fit, you could buy some thin Vi liners. To be honest stock liners are bad made.
From The Netherlands
Now where to find thin Vi liners. Hadn't thought about seeing if I could find a thinner liner.
Will also try without foot beds and no sock (which will make skates stink)
Then again I am also debating new skates (but that is a whole other discussion)
Thanks.
Just look for powerslide e.g smart liner, just aware when buying choose for a thinner lining foam version.
From The Netherlands
😀